How can install dhcp

Specify the DNS suffix. The DNS suffix is used for resolving unqualified or incomplete host names. TFTP Server. Boot File. Specify location and file name of the TFTP server boot file. Tip: Examine your network setup for guidance on how to best configure these settings. Jumbo Frames are Ethernet frames that are larger than bytes. They are designed to enhance Ethernet networking throughput, and to reduce CPU usage when transferring large files.

QTS supports the following Jumbo Frame sizes: bytes default bytes bytes bytes. Use the buttons below to navigate through the lesson. Stateless mode refers to the default addressing mode for IPv6 hosts, in which addresses are configured without the help of a DHCP server. Options can still be obtained from the DHCP server. When an IPv6 host is configured to obtain an address automatically, instead of using a DHCP server, the host in stateless mode self-configures an address compatible with the local subnet by exchanging Router Solicitation and Router Advertisement messages with a neighbouring IPv6 router.

You can disable stateless mode on the DHCP server and enable it to respond to IPv6 hosts that have been enabled for stateful addressing. IPv6 address of the DNS server. Click add features. That completes the install of the DHCP role. Move onto the next section for steps on configuring the DCHP server.

The next steps are to configure a new scope, configure scope options and ensure clients can access the DHCP server. Why is a DHCP server needed? Start the DHCP wizard by issuing the following command at the command line:. Respond to the wizard prompts, as follows:. Your summary page should look similar to the following example:. Verify your configuration information, and click Finish.

When you are prompted to configure addresses for the server, click Yes. The Add Address to Network wizard is displayed. Verify your configuration information and click Finish. In the Address Properties window, do the following:.

For example:. Go to Modify Service Options, and do the following:. After you power on the storage array, ping the address.